Stanbio HemoPoint-H2 - Sampling and Testing Procedure; Taking a Sample

To Next Page

To Previous Page

Set up

HemoPoint

H2 User’s Guide

As the built-in battery has not yet been charged, the photometer

must first be connected to the power adaptor (supplied) and

plugged into an electrical socket until the battery is completely

charged.

This procedure is necessary in order for the capacity of the

battery to be checked and the charge indicator to function

correctly. Further information on this can be found in Section 6.2

“Charging and care of the battery”.

3.3.2 To operate using the power adaptor

Use the power adaptor to operate the photometer, noting the

following steps when connecting the power adaptor:

1. Insert the small round plug on the connecting cable of the

power adaptor into the appropriate socket (6VDC) at the

back of the photometer.

Illustration 3: Connecting the power adaptor.

TIP