Stanbio HemoPoint-H2 - Printing out Results; Deleting the Stored Test Data

Further functions
HemoPoint
®
H2 User’s Guide
33
If the estimated Hematocrit mode has been activated the
hematocrit result will be displayed as well (see Section 5.3.8.1
“Hematocrit mode”).
5.2.2 Printing out results
In order to print out from memory (data storage) you must have a
printer connected. Instructions for this can be found in Section
5.4 “Standard print mode” and Section 5.5 “Expanded print
mode”.
You can print out results as follows:
 From the memory (data storage) display, press the
button
Options
.
 Select the entry “Print” using the buttons.
 Confirm the selection with
OK
, to print out the
results, otherwise press
ESC
, in order not to
print.
Printing out the results can take a few seconds. Following
printing, the photometer changes back again to display the
memory (data storage).
5.2.3 Deleting the stored test data
With this function the entire data storage (all results) is deleted.
To delete the data storage, proceed as follows:
 From the memory (data storage) display, press the
button
Options
.
 Select the entry “Delete” using the buttons.
TIP