Stanbio HemoPoint-H2 - Battery Operation; Stand-By Mode

To Next Page

To Previous Page

Set up

HemoPoint

H2 User’s Guide

The individual symbols and their meanings are explained in

Section 3.3.5 “Displays and symbols in the ready mode“.

Now you can either start your testing, view results in the memory,

or carry out adjustments in the Menu.

You can find tips on this in Sections 4 “Sampling and testing

procedure”, 5.2 “Memory (data storage) and 5.3 “Menu

functions”.

If the photometer is not in use for some time, it switches into the

energy-saving, Stand-by mode (see Section 3.3.4 “Stand-by

mode”).

3.3.3 Battery operation

The HemoPoint

H2 photometer automatically switches to battery

operation when you unplug the power adaptor from the electrical

socket, or from the instrument (assuming, of course, that the

battery is sufficiently charged).

When the battery is fully charged it will operate for a period of at

least 100 hours.

Tips on charging the battery and battery maintenance can be

found in Section 6.2 “Charging and care of the battery”.

To avoid problems while testing during battery operation, also

note the tips in Section 3.2 “Setting up the photometer”.

3.3.4 Stand-by mode

The photometer does not have a separate On/Off-switch. It is

designed so that it automatically switches to the Stand-by mode

when you are not operating the instrument for a certain time

TIP

WARNING!