– 15 –
9) A printed piece of thermal paper may become electrically charged. If the printer is
placed vertically or mounted on a wall, the cut piece of paper may stick to the printer,
instead of falling. Beware that this could cause a problem if you use a stacker that
stores the pieces of paper that fall freely.
10) Do not change the paper width during use. The thermal printing head, rubber roller,
and cutter wear differently according to the paper width. This can cause the printing
or cutter movement to malfunction.
11) Do not transport the printer with its cover open and holding it by the cover.
12) Do not forcibly pull on the interface cable, power cable, or cash drawer cable that is
connected. To detach a connector, make sure to grasp it at the connector portion,
without applying excessive stress on the connector at the printer.
Notes on Using the Auto Cutter
1) To print after a cut, feed 1 mm (8-dot line) or more of paper.
2) If the cutter is not in its home position after an error, rst eliminate the cause of the
error; then, turn the power back ON.
3) A margin of 5 mm or more is recommended from the end of the printed area to the
cutting position.
4) Do not attempt to remove the paper during a cut, as this can cause a paper jam.
To Next Page
Loading...
