Star TSP650 - 11. Dip Switch Setting

– 33 –
11. Dip Switch Setting
Two DIP switches are provided at the bottom of the printer, and can be set as given in the table
below. Be sure to set the power switch to o before changing the settings. It is recommended to
use a pointed item like a pen or at-blade driver screw to change the settings. e settings will
become eective when the power switch is set to on again.
e following is the procedure for changing the settings on DIP switches.
1. Make sure the printer is turned o.
2. Remove the screw from the DIP switch blind. en take o the DIP switch blind, as shown
in the illustration below.
3. Set the switches using a pointed tool, such as a pen or at-blade screwdriver.
4. Replace the DIP switch blind. en secure it with the screw.
e new settings take eect when you turn on the printer.