13-3
2 Recommended lubricating and hydraulic fluids
Be sure to use the specified lubricants.
*1: At ambient temperatures higher than 50°F (10°C), use an oil conforming to GL-5, SAE140 or SAE85W-140 if the vehi-
cle is used under heavy load conditions, including frequent driving on prolonged steep upgrades.
Parts Category Classification
Viscosity
Driving
condition
SAE viscosity
number
Engine Engine oil
API CD, CD/SF, CE,
CE/SF, CF-4 or JASO
classification DH-1
Below 32°F (0°C) 10W–30
Above 5°F (–15°C) 15W–40
5 to 59°F
(–15 to 15°C)
20W–20
23 to 104°F
(–5 to 40°C)
30
Above 86°F (30°C) 40
Manual transmission
Gear oil
API GL-3
Temperate climate 80
Warm climate 90
API GL-4
Tropical climate 90
Engine oil API CC
Long period of high-
speed driving
30 or 40
Automatic
transmission
Automatic
transmission fluid
Exxon Mobil:
Mobil ATF3309 or
equivalent
––
Axle housing
*1
Gear oil API GL-5
Below 104°F (40°C) 90
Above 104°F (40°C) 140 or 85W–140
Limited-slip
differential
Gear oil for limited-
slip differential
API GL-5
Genuine Gear Oil,
Part No. 8149630EX
–90
Power steering
Automatic
transmission fluid
DEXRON, DEXRON
II or DEXRON III
––
Brake, Clutch Brake fluid
SAE J1703,
FMVSS No. 116
(Grade DOT3)
––
Chassis grease
fittings (rear spring
pin, king pin)
Door hinge
Anchor hooks
Chassis grease
NLGI No. 1 (Li soap)
Consistency 310 to
340 (at 77°F or 25°C)
Dropping point 266°F
(130°C) or higher
––
Wheel bearing
propeller shaft
(universal joint, slip
joint)
Wheel bearing
grease
(Multipurpose type
grease)
NLGI No. 2 (Li soap)
Consistency 265 to
295 (at 77°F or 25°C)
Dropping point 365°F
(185°C) or higher
––
Midship bearing Bearing grease
NLGI No. 3 (Li soap)
Consistency 220 to
250 (at 68°F or 20°C)
Dropping point 482°F
(250°C) or higher
Usable temperature
range –40 to 302°F
(–40 to 150°C)
––
To Next Page
Loading...