11-7
4. Lower the secondary release (lever B) until
the pin engages with the latch . Make sure
that lever B is locked in place and cannot be
lifted.
NOTE:
If lever B cannot be lowered until the pin engages,
tilt the cab again and repeat the lowering procedure
from the beginning.
5. Turn ON the ignition switch, and make sure that
the cab tilt warning does not illuminate.
If the warning illuminates and the buzzer
sounds, the cab is not locked completely. If this
happens, tilt the cab again, repeat the lowering
procedure from the beginning, and lock it again.
NOTE:
Sometimes the switch that activates the cab tilt
warning does not pop out when lever B is locked in
place. If you continue to get a warning light with
lever B locked, move the switch manually if neces-
sary. if this does not work, replace the switch.
Use the following pretrip inspection checklist to help
ensure that the vehicle components are in good
working condition before each trip. If you find any
problem which you are unable to correct yourself,
bring the vehicle to an authorized Sterling service
facility.
1 Before starting the engine
Pretrip inspection
Z10678
Z11895
Z15024a
To Next Page
Loading...