Stihl GS 461

47GS 461
Crimped side of the blade
receptacle (1) must face the switch
shaft bearing.
: Push blade receptacle (1) of
ground wire (4) onto the contact
spring (2)
: Push in short-circuit wire (3) and
ground wire (4) between fin
(arrow) and housing wall
– Short-circuit wire (3) must be
routed below the ground wire (4)
: Install switch shaft, b 9.1.1
: Short-circuit wire (1) and ground
wire (2) must be between the fin
(arrow) and housing wall, push in
completely if necessary
– Short-circuit wire (1) must be
routed below the ground wire (2)
2411RA064 TG
1
2
3
4
2411RA072 TG
1
2
: Check correct functioning
– The eyelet (1) of the short-
circuit wire must touch the
contact spring (arrow) in position
"0"
– Reassemble remaining parts in
reverse order
2411RA119 TG
1