Stihl GS 461

83GS 461
11. Special tools
New special tools
Existing special tools
No. Designation Part No. Use Remarks
1 Set of tools 3/8" G 5805 007 1001 Unrivet and rivet cut-off chain
- Insert 3/8“ Bursting of segments
- Die Unriveting of tie straps
2 Service tool kit AS 5910 007 2222 Removal and installation of
crankshaft (clutch side)
3 Support mounting kit 5910 850 1651 Clamping machine to assembly stand
4 Piston support 5910 893 5300 Positioning piston
5 Installing tool 5910 893 9601 Removing and installing collar nuts on
chain sprocket cover
No. Designation Part No. Use Remarks
1 Carburetor and crankcase
tester
0000 850 1300 Test crankcase and carburetor for
leaks
- Connector 0000 855 9200 Testing carburetor for leaks
- Hose for leakage test 1110 141 8600 Testing carburetor for leaks
- Plug for leakage testing 1122 025 2200 Testing decompression valve for leaks
2 Sealing plate 0000 855 8106 Checking crankcase does not leak
3 Installing tool 0000 890 2201 Installation of starter rope guide
bushing
4 Clamping strap 0000 893 2600 Tensioning the piston rings
5 Locking strip 0000 893 5903 Blocking the crankshaft
6 Bit T 27 x 125 0812 542 2104 Removing and installing spline socket
head screws with electric or pneumatic
screwdrivers; tightening down screws
with torque wrench
7 Assembly drift 1108 893 4700 Removing and installing piston pins
8 Puller 1110 890 4500 Removing the flywheel
9 Setting gauge 1111 890 6400 Setting the air gap between ignition
module and flywheel
10 Press sleeve 1115 893 4600 Pressing in oil seal
(Ignition side)
11 Assembly tube 1117 890 0900 Hooking in clutch spring
12 Press sleeve 1118 893 2401 Pressing in oil seal
(Clutch side)
13 Assembly sleeve 1118 893 4602 Protection of the oil seal
(Clutch side)
14 Press arbor 1118 893 7200 Pressing in ball bearing (clutch side)