Stihl GS 461 - Service Accessories

84 GS 461
No. Designation Part No. Use Remarks
15 Press arbor 1120 893 7200 Pressing in ball bearing (ignition side)
16 Combination wrench 1129 890 3401 Spark plug 1)
17 Service tool ZS
including
Washer 5910 893 2103
5910 007 2201 Removal and installation of
crankshaft (ignition side)
– Washer 5910 893 2101 Pulling together the crankcase
-Screw sleeve 5910 893 2420 Installing crankshaft
18 Engine analyzer
STIHL MDG 1
5910 840 0200 Running motor diagnosis
19 Test flange 5910 850 4200 Leakage test
- Sleeves 5910 893 1701 Spacer sleeves for test flange
20 ZAT 4 ignition tester 5910 850 4503 Testing ignition system
21 ZAT 3 ignition tester 5910 850 4520 Testing ignition system
22 Torque wrench 5910 890 0302 Screw connections (0.5 to 18 Nm)
23 Torque wrench 5910 890 0312 Screw connections (6 to 80 Nm)
24 Assembly tool 12 5910 890 2212 Fitting hookless snap rings in piston
25 Screwdriver 5910 890 2304 Setting carburetor with limiter caps
- Setting washer 5910 893 6600 Supplement to screwdriver
5910 890 2304
26 Bit T 27 x 150 5910 890 2400 IS-P screws (4 mm)
27 Assembly hook 5910 890 2800 Detaching tension springs from clutch
shoes
28 Stud puller M 8 5910 890 3000 Screwing in and tightening rail
mounting studs
29 Assembly stand 5910 890 3101 Holding machine for servicing / repairs
30 Wiring tool 5910 890 4000 Installing electrical leads
31 Puller 5910 890 4400 Removing oil seals
- Jaws (with profile no. 3.1) 0000 893 3706 Extracting oil seal(s)
32 Puller 5910 890 4500 Pulling out limiter caps
33 Screw sleeve 5910 893 2409 for assembly tool kit AS 5910 007 2222
– Pulling together the crankcase
34 Stud puller, M8 5910 893 0501 Removing rail mounting studs
35 Socket, 13 mm, long reach 5910 893 2804 Removing and installing
decompression valve
36 Assembly hook 5910 893 8800 Removing pickup body
Remarks:
1) Use only for releasing.