Stihl GS 461

65GS 461
: Insert throttle trigger (1) in the
handle so that the holes on the
throttle trigger and handle line up
: Center throttle trigger (1) with
punch (2) and drive in pin (3) until
it is equidistant on both sides
: Press end of the torsion
spring (1) toward the handle
: Position trigger interlock (2) so
that the limit stop (3) engages in
the throttle trigger
: Hook the torsion spring (1) onto
the trigger interlock
: Press the trigger interlock (2) into
the bearing points (arrows) until it
clicks into place
The trigger interlock may pop out.
3443RA394 TG
3
21
3443RA398 TG
2
1
3
: Hook handle molding (1) with the
Hook tabs (2) into the openings
(arrow) and fit in position
– Insert and tighten the screw
– Open the throttle wide and hold,
then hook throttle rod into throttle
trigger – throttle trigger must only
turn if the trigger interlock is
pressed
– Check correct functioning
– Press throttle trigger down
completely, the lever on the
carburetor must be at full throttle
and must not move any further in
open direction
– Reassemble remaining parts in
reverse order
9.3 Throttle rod
– Remove filter base, b 10.2
– Remove handle molding, b 9.2
– Open the throttle wide and hold,
then unhook throttle rod from
throttle trigger
3443RA399 TG
2
1
1
2
3443RA400 TG
: Turn throttle rod (1)
counterclockwise and unhook
from throttle trigger (2) of the
carburetor
– Remove throttle trigger with
bushing and baffle
– Examine the individual parts,
replace if necessary
Installation
: Guide throttle rod (1) with the
square part (arrow) from the
bottom through the bushing (2)
: Press studs (1) into the hole of
the baffle
3443RA401 TG
12
3443RA402 TG
1