Stihl GS 461

60 GS 461
8.4 Rubber buffers / support
: Push out rubber buffer (1) to the
side
– Examine rubber buffer, replace if
necessary
Installation
– Use STIHL press fluid to simplify
the following assemblies, b 12
: Push rubber buffer (1) with the
rubber tab into the guide until the
lug (arrow) protrudes – lug stops
the rubber buffer from sliding out
1
2411RA097 TG
1
2411RA098 TG
8.4.1 Water hose
: Apply a screwdriver to the hose
clips (arrow) and turn slightly to
open the clip
: Remove water hose (1) at both
connectors and remove hose
clips
1
2411RA080 TG
Installation
: Guide water hose (1) through the
opening in the support (2)
: Fit hose clip (3) and push water
hose (1) as far as it will go onto
the connector (arrow)
: Fit hose clip (1) and push water
hose (2) as far as it will go onto
the connector (arrow)
2411RA099 TG
1
2
3
2
1
2411RA100 TG