Stihl GS 461

63GS 461
9. Actuating levers
9.1 Master Control lever
The positions of the Master Control
lever are described in the
Instruction Manual.
9.1.1 Removal and installation
– Remove filter base, b 10.2
– Remove throttle rod, b 9.3
: Set the switch shaft (1) to "0"
: Prise out switch shaft (1) on the
bearing (arrow) and carefully pull
off from switch housing (2)
– Short-circuit wire (3) is still fitted
to switch shaft (1) and must not
be damaged
: Pull short circuit wire (1) out of
the guides (arrows)
2411RA111 TG
1 3
2
2411RA112 TG
1
: Lift eyelet (1) of the short-circuit
wire over the guide (2) and pull
out
– Check the switch shaft, replace if
necessary
Installation
: Push eyelet (1) onto the peg (2)
so that the crimped side (arrow)
faces in
: Place eyelet (1) in guide (3)
2411RA113 TG
1
2
2411RA114 TG
2
3
1
: Guide short-circuit wire (1) so
that it lies snug around the switch
shaft (2) and press or hook into
guides (arrows) – short-circuit
wire (1) must be snug against the
switch shaft (2)
: Orient switch shaft (1) so that the
lever (2) faces the carburetor
: Lift contact spring (3) slightly and
push switch shaft (1) with the
bearing journal (4) into the hole
(arrow) of the switch housing
2411RA115 TG
2
1
2411RA116 TG
1
4
32