Stihl GS 461

56 GS 461
– Use STIHL press fluid to simplify
assembly, b 12
: Push the ring (1) onto the
sleeve (2) as far as it will go
– Fit tank housing on ring buffer –
the holes must line up
: Push sleeve (1) with ring into the
ring buffer, screw in screw (2)
and tighten
– Reassemble remaining parts in
reverse order
3443RA331 TG
2 1
3443RA332 TG
2
1
8.1.2 Ring buffer guard / clutch
side
: Unscrew screw (1) and remove
side plate (2)
: Pry out plug (1)
: Remove screw (1) and prise out
ring buffer (2)
– Examine the ring buffer, replace if
necessary
2411RA076 TG
1
2
1
2411RA077 TG
2
1
2411RA078 TG
: Remove rubber ring (1) from stop
dome of the tank housing and
push through the hole (arrow) of
the crankcase
– Check rubber ring, replace if
necessary
Installation
– Use STIHL press fluid to simplify
assembly, b 12
: Push rubber ring (1) through the
hole (arrow) of the crankcase and
press as far as it will go onto the
stop dome of the tank housing
Rubber ring must not become
jammed between the ring buffer and
tank housing.
2411RA079 TG
1
2411RA079 TG
1