Stihl GS 461

68 GS 461
: Push fuel hose (1) and impulse
hose (2) back slightly
– Fuel hose and impulse hose
are released
: Push out bushing (1) and pull off
carburetor (2)
– Examine the carburetor and
repair or replace it if necessary
– Check sleeve, remove and
replace if necessary
Installation
Washer (1) and sleeve (2) must be
in place.
2411RA128 TG
1 2
2411RA129 TG
2 1
3443RA064 TG
1
2
: Press carburetor (1) over the
studs (arrows) – sleeve (2) must
be in place
Fuel hose must be located in the
mount (arrow).
: When fitting, make sure that the
connectors are pushed into the
fuel hose (1) and impulse
hose (2)
– Install throttle rod and check
operation, b 9.3
2411RA130 TG
1
2
2411RA128 TG
1 2
– Use STIHL press fluid to simplify
assembly, b 12
: Press bushing (1) into the holes
of the handle housing until the
rubber strips fully protrude on the
opposite side
– Install filter base, b 10.2
– Install air filter, b 10.1
– Check correct functioning
– Reassemble remaining parts in
reverse order
2411RA132 TG
1