Still EXV 10 Basic - Controls for Switching on and Switching off

Controls for switching on and
switching off
Switching on and switching off are performed
using:
●
the key switch (standard version)
●
or the numeric keypad "Digicode" (optional
version)
Standard version with key
On the standard version, the key has three po-
sitions:
●
“0” position: Truck switched off.
●
(2)"Tortoise" position: truck switched on and
truck speed limited.
●
(3)"Hare" position: truck switched on and
standard (NOT limited) truck speed.
– To select the truck drive mode from the two
available modes ("Tortoise" or "Hare"), turn
the switch key to the desired position.
– To switch off the truck, turn the key to the
“0” position.
Version with "Digicode" (optional)
– On the optional version with Digicode: start
the truck by following the procedure descri-
bed in the relevant paragraph (Digicode op-
tion).
Then, turn the selector to the desired position
depending on the desired drive mode:
●
(2)"Tortoise" position: truck switched on and
truck speed limited.
●
(3)"Hare" position: truck switched on and
standard (NOT limited) truck speed.

2343
2
3

Overview
3
Instruments and controls
34 45728043478 EN - 11/2021 - 09