Still EXV 10 Basic - Using the Truck with the Tiller Always Active - Creep Speed Function (Optional)

– Reduce the angle of rotation of the control
throttle compared to the neutral position to
brake the truck electrically.
Reverse travel
– Use your thumb to press on the upper part
of the throttle.
– The speed increases with the movement of
the throttle. The speed is limited to 4 or
6 km/h depending on the position of the
key.
– Reduce the angle of rotation of the control
throttle compared to the neutral position to
brake the truck electrically.
Using the truck with the "Tiller
always active — Creep Speed"
function (optional)
The "tiller always active" function can be ena-
bled when operating the truck in confined
spaces.
This function allows the truck to travel and
the forks to be lifted with the tiller in any posi-
tion. Unlike the standard version, by follow-
ing the instructions below, the truck functions
(travel and lifting/lowering of forks) are also
active with the tiller in the vertical position.
To enable truck lifting with the tiller in the verti-
cal position:
●
Press and hold the button (3)
●
Then press the fork lifting button
●
Release the button (3) to disable this func-
tion.
To enable travel with the tiller in the vertical
position:
●
Press and hold the button (3)
●
Then turn the throttle (4) in the desired di-
rection
●
The truck activates creep speed. During
travel at creep speed with the tiller in the
vertical position and the button (3) pressed,
if the operator tilts the tiller to the working
position (see
⇒ Chapter "Tiller positions",
Page 36 ), creep speed is disabled and the
OM2283
3
4
4

Use
4
Driving
74 45728043478 EN - 11/2021 - 09