Maintenance plans
Maintenance plans
Key to symbols in table:
●
▲
= Every 1000 hours or at least every
12 months (whichever comes first), unless
local regulations require more frequent in-
tervention.
ENVIRONMENT NOTE
During maintenance operations, follow the in-
structions provided in the "Safety guidelines
relative to operating materials" section in
"Chapter 2".
Servicing work every 1000 hours
Transmission
Reduction gear: check that it is correctly mounted
Reduction gear: check for any oil leakage
Drive motor: check that it is correctly mounted
Forks
Check condition of forks
Grease the rods and levers
Check the bushes and levers
Steering/wheels
Steering: visually inspect the mounting of the tiller
Steering unit bearing: grease (if there is a lubrication nipple)
Wheels
Wheels and rollers: check for any damage, foreign matter or signs of wear
Wheels: check that they are at the correct tightness
Rollers: check that they are correctly mounted
Brake
Electromagnetic brake: check for signs of wear and any adjustment
Check the truck braking
Electrical system
Battery: check the battery condition and that it is correctly mounted
Battery: check the condition of the cables and sockets
Battery: service the battery according to the manufacturer's instructions
On-board charger (if present): clean
Maintenance
5
Maintenance plans
10545728043478 EN - 11/2021 - 09
To Next Page
Loading...
Need help?
General
