Stober SD6 - Page 32

ID 442710.00 32WE KEEP THINGS MOVING
More about PROFINET?
6
Operation manual PROFINET
Error codes – "Error values"
The following table shows the possible error codes together with coding of the
error cause.
Value Meaning
00
hex
Parameter unknown or configuration stopped
01
hex
Access to parameter that may not be changed
02
hex
Access to parameter with a value outside of the limit
values
03
hex
Access to unavailable subindex (array parameter)
0B
hex
User level not reached
11
hex
This parameter may not be changed in the current device
state; switch the enable off
14
hex
Invalid value within its maximum limits; only occurs for
selection parameters with discontinuous definition range
16
hex
Inconsistent specification in the parameter addressing:
one or more incorrect values in the Attributes, No of
Elem., Parameter Number and Subindex fields
17
hex
Invalid format specification
18
hex
Specification in the No of Elem. and No of Val. fields are
contradictory
21
hex
Illegal Request ID = "Service not supported" applies for
errors in the header of the task block
A5
hex
Unspecified error
B0
hex
Parameter service currently not possible, no valid
parameter description available
B2
hex
Parameter address unknown (parameter or element does
not exist)
B3
hex
Read-Write access not possible on this parameter
address (no parameter, but type or forbidden by hide
function)
B9
hex
Parameter service: value in definition gap (observe
ENUM list)
BA
hex
Parameter service: clash with other values
C0
hex
Parameter service: error in pre-read function
C1
hex
Parameter service: error in post-write function, value has
already arrived
Value Meaning