Safety instructions 1
General safety instructions 1.5
1-9
1.5 General safety instructions
1.5.1 Danger by mechanical parts
Reason Protective measures
Danger of injury by rotating or
moving parts
Do not reach into the running machine.
Always stop the machine during an
intervention
Switch off the machine during mounting
activities and secure it against being
switched on again.
Wear safety glasses.
Injuries may be caused by pieces
broken off from needles when the
carraige and needles collide at
damaged points.
Wear safety glasses.
Danger of burns by motors; the
needle bed and parts of electric
controls that can become hot.
Wear protective gloves.
Danger of injury
in the case of mounting activities by
pressure and tension springs
(for. e.g. in the main take-down and
in the engaging rod), which could
have stored potential energy.
Relieve the springs before removing.
Carry protective equipment.
1.5.2 Danger by electrical energy.
Reason Protective measures
Danger to life by electrical shock
during work on the electrical
assemblies of the machine.
Work is to be done only by an electrician.
Switch off machine
Remove building fuses.
Secure the machine against being
switched on again.
Danger to life by electric shock in
case of electric faults like loose or
defective connectors/plugs or
braised or damaged cables.
Deactivate the machine immediately.
Remove building fuses.
Secure the machine against being
switched on again.
Eliminate all faults that can be caused by
an electrician.
To Next Page
Loading...
