Safety instructions 1
Safety instructions for the individual Operation Phases 1.6
1-11
1.6 Safety instructions for the individual
Operation Phases
Avoid any operational mode that might be prejudicial to safety!
Take the necessary precautions to ensure that the machine is used
only when in a safe and reliable state!
Operate the machine only when all the Protective and security
equipment is available and functional.
In particular, malfunctions which could limit the safety of the machine
are to be remedied (or repair is to be commissioned) immediately!
Observe the warnings on the machine and in the Instruction leaflet by
all means. By doing so you will protect yourself and the others from
dangers and will help to avoid damages to the machine and other
tangible assets.
No one may remain inside the machine. Risk of death!
Observe the start-up and shut-down procedures and the indicators.
Before starting up or setting the machine in motion, make sure that
nobody is at risk!
1.6.1 Safety instructions for the transport
Type of risks Measures
Danger of injury by heavy loads Country-specific regulations for the
prevention of industrial accidents for the
transport of heavy loads are to be
observed.
The relevant Country-specific laws and
regulations to be observed during
transport with ground conveyors.
1.6.2 Safety instructions for lubrication
Type of risks Measures
Danger of injury by heavy loads Observe all technical data of the
machine.
Country-specific regulations for the
prevention of industrial accidents for the
transport of heavy loads are to be
observed.
Danger of damage to the machine. Remove all transport locks.
Connect side protective shrouding (on
left and right-hand sides of machine)
Environment Pollution Dipose off protective films in an
environmentally responsible manner.
Observe the country-specific laws and
regulations.
To Next Page
Loading...
