Stratasys F170 - Rear Top Cover

174
REAR TOP COVER
Required Tools
• 2.5 mm hex wrench
Removing the Rear Top Cover
1. Power OFF the printer. See “Powering Off” on page 169.
2. Open the oven door to release the top cover latch.
3. Open the front top cover.
4. Using a 2.5 mm hex wrench, remove the screws (2) that secure the rear top cover to the cross
bar.
5. Slide the rear top cover back and remove it from the printer. See Figure 7-15.
Figure 7-15: Rear top cover removal
Installing the Rear Top Cover
1. Align the rear top cover with its mounting holes (2) in the cross bar.
2. Using a 2.5 mm hex wrench, install the screws (2) that secure the rear top cover to the cross bar.
See Figure 7-15.
3. Close the front top cover.
4. Close the oven door.