87
To configure this setting, press anywhere within the row; the UPnP page will be displayed. Use the radio buttons
within the page to turn the setting On and Off as needed; On is selected by default.
Figure 4-54: Configure UPnP
WIFI
The Wifi setting gives you control over the printer’s Wi-Fi capabilities. Please note that the functionality of this
setting is dependent upon the use of a Wi-Fi dongle purchased for use with the printer. When this setting is set
to On, you will be able to configure the printer to scan for and connect to an available Wi-Fi network. You will
then be able to send part files to the printer via this network. When set to Off, Wi-Fi capabilities will be disabled
and you will instead need to send part files to the printer via your facility’s Ethernet connection or through the
use of a USB flash drive (see “Configuring the Network” on page 14 for details).
Figure 4-55: Wifi
To Next Page
Loading...
