Stratus SAE-C10C - Table of Contents

2
Directory
1-The amin features of the equipment ……………………………………………………………………………………4
1.1-Product descripon……………………………………………………………………………………………………4
1.2-Features of the product ………………………………………………………………………………………………4
1.3-Satey mark of the product ……………………………………………………………………………………………4
2-Technical Date of the equipment ………………………………………………………………………………………5
2.1-Product Dimensions …………………………………………………………………………………………………6
2.2-Tools required…………………………………………………………………………………………………………7
3-Installaon ………………………………………………………………………………………………………………8
3.1-Preparaon ……………………………………………………………………………………………………………8
3.2-Foundaon requirements……………………………………………………………………………………………8
3.3-Installaon steps ……………………………………………………………………………………………………10
4-Equipment Installaon …………………………………………………………………………………………………13
4.1-Assemble Columns …………………………………………………………………………………………………13
4.2-Assemble overhead top beam ………………………………………………………………………………………13
4.3-Posion Columns ……………………………………………………………………………………………………16
4.4-Install overhead top beam……………………………………………………………………………………………16
4.5-Adjust Carriage………………………………………………………………………………………………………17
4.6-Install Equalized Cables (2 Cables in total) …………………………………………………………………………17
4.7-Install Hydraulic Hose (2 Hose in total) ……………………………………………………………………………18
4.8-Install Safety Lock Release Cable……………………………………………………………………………………19
4.9-Install Power Unit……………………………………………………………………………………………………19
4.10-Safety Lock Release Cable & Hose & Top Limiter Switch Wire Protecon cover…………………………………20
4.11-Install Anchor Bolt…………………………………………………………………………………………………22
4.12-Install Arms and Pulling Rod………………………………………………………………………………………22
5-Check Before Start………………………………………………………………………………………………………23
5.1-Mechanical Installaon Check………………………………………………………………………………………23
5.2-Electrical Hook Up Check……………………………………………………………………………………………23
5.3-Hydraulic System Tesng ……………………………………………………………………………………………24
5.4-Load Test ……………………………………………………………………………………………………………24