Stratus SAE-C10C - 1-The Amin Features of the Equipment; Product Description; Features of the Product; Satey Mark of the Product

4
1-The main features of the equipment
1.1-Product descripon
This product is a hydraulic li. The product is manual single point lock release, easy to operate. It is suitable for
inspecon, repair and maintenance of a vehicles below 10000lbs.
1.2-Features of the product
When the power unit of the hydraulic li is connected to the power supply, press the switch, the gear pump works,
and the hydraulic oil pushes the piston rod up, which is brought to the pulley and the pulley and the safety lock
tooth will blink and bite each other during each ascent. At the same me, to ensure that the hydraulic system will
not cause slippage.
1.3-Satey mark of the product
Do not come under the vehicle during
operaon. This can cause injury and
death.
Evacuate to a safe place instantly the
event that the vehicle ps. This can cause
injury or death.
Before lowering the li, check that
there are no obstrucons under the
vehicle or the li arms.
Do not operate damaged equipment.
When the vehicle is lied, do not rock
it as this may dislodge it.
Only trained person may operate the
equipment. Inexperience can cause acci-
dents.
Do not li a vehicle using on pair of
arms only.
Do not operate the push buon except
the worker.
Do not rock the vehicle when lied. Do
not use a high pressure cleaner to the
vehicle lower part.
To avoid being electrocuted, disconnected
the main power before opening the con-
trol panel.
To avoid injury, keep your feet clear of
the arms and carriages.
Read and fully understand the manual
before using the li.
Not allowed unauthorized persons in
the work area.
Before going under the li. Make sure that
the safety pawls are engaged.
Posion vehicle with center of gravity
midway between adapters.
Make sure that the front and back balance
when placing the car, otherwise the car
will fall.
Do not modify the control panel or the
safety funcons as this may impair
their funcon.