Strong SRT 5405 - Quick Start

10
Quick Start
This section explains how you can quickly set up your
using he cables provided. For
detailed instructions, see “How to Connect” on page 11.
Install batteries in the remote control. See page 9.
Connect the
to the antenna wall plate. See page 11.
Using the supplied Component cable (blue–red–green) or the yellow lead of the
supplied Composite cable, connect the
to the TV. Make sure you match the
colour of a lead with the colour of a socket. (This step provides video output to your TV.)
See
“How to Connect” on page 11.
Connect the white and red leads of the Composite cable between the
and
the TV, again matching the colour of a lead with the colour of a socket. (This step
provides audio output to your TV.) S
ee “How to Connect” on page 11.
Turn on the
and the TV. The Strong Technologies banner appears on your TV
screen, followed by a message asking if you want to automatically search for channels
and stations. (If you don’t see the banner and message, press EXIT and then FORMAT on
the remote control until you do.)
Press OK to automatically scan for digital broadcasters in your area. When the scanning
is finished, the menu closes and a local digital TV channel will be showing.
See “Basic operations” on page 16 for general instructions on using the
to
select TV channels and radio stations.
1
2
3
4
5
6