Strong SRT 5405 - System Settings

29
Note that some of these settings are restricted by the type of connection you have made
between the
and your TV. For example:
• If you have used an S-Video or a Composite connection, the Video def setting must be
set to 576i.
• If you have used an S-Video connection, the Video output setting must be set to YC.
• If you have used an HDMI connection, the Video output setting must be set to YPbPr.
• If you have connected the
to a Dolby Digital decoder amplifier, the S/PDIF
output setting must be set to AC3.
4. Select an option you want to change. If necessary, press
CHd or CH
c
until the option is
highlighted.
5. With the option you want to change highlighted, press
VOL
e
or
VOL
f
to step through the
allowable values (shown in the panel at the right of the screen). Stop when the value you want
is displayed.
6. If there is another option you want to change, repeat this procedure from step 4.
7. When you have finished, press OK.
8. A message appears asking you to confirm that you want to save the changes. To proceed,
press OK. To cancel, press MENU or EXIT.
9. Press EXIT until you return to normal viewing.
System settings
1. Press MENU on the remote control. The Main Menu appears.
2. If System Setting is not highlighted on the main menu, press
CHd or CH
c
until it is and then press
OK. The System Setting menu appears.
3. If Sys Setting is not highlighted on the menu, press CHd or CH
c
until it is and then press OK. The
Sys Setting menu appears.