English
Timeshift Status: Choose between Enable to activate the Timeshift function or Disable to switch
it off. This function will also automatically be set to Enable if you press 2 on
the remote and have USB device connected.
Timeshift Step: Select the time size step in minutes and seconds which you like to make by
using t u during navigation in Timeshift modes. Use the 0~9 buttons to
enter the time.
Timeshift Duration: Select the maximal time (size) which is reserved for the time shift function.
Use the 0~9 buttons to enter the duration.
Record Duration: Select the default maximum time for recordings that can be started with the
4 button. Use the 0~9 buttons to enter the duration.
Start Record earlier: If you want to start the recording, set under timer from EPG some minutes
earlier than the time obtained from the programme guide.
End Record later: If you want to stop the recording, set under timer from EPG some minutes
later as time obtained from the programme guide.
REC Icon: If you start a recording, an icon will be shown in the left upper corner of your
TV screen with the text “REC”. Default is set to On. Select 5 Seconds or 10
Seconds to let the icon disappear after the selected time.
7.4.3 Storage Device Setup
This option shows relevant information about the connected USB device. In this menu you can also
format your USB storage device and safely remove.
Select Storage Device Setup in the Multimedia menu and press OK to enter.
Now you will see all details as free and used space sizes and used file system.
Press the RED Safely Remove button and press OK to safely disconnect the USB device. The receiver
will display a message indicating that you can now safely remove your storage device from the
receiver. Press the BLUE Format USB Device button to format the connected USB device.
Please, enter your PIN code to access this menu and press OK to start formatting.
Press to leave this menu.
NOTE: After performing the Safely Remove function, the USB device is no longer
accessible by your receiver. To gain access to you’re the storage device
again, re-insert it or switch the receiver to standby and on again.
WARNING: Formatting will permanently delete ALL data stored on the connected
device. Please make a backup copy of all data you wish to keep before
entering the Format menu. STRONG cannot be held responsible for loss of
data from USB devices used with this receiver.
19
To Next Page
Loading...
