Strong SRT 8213 User Manual

English
NOTE: If, after a software update, the receiver should behave in an unexpected
way, please perform a factory reset as well. See chapter 7.1.4..
WARNING: After an update the receiver restarts automatically. During the upgrade
process NEVER disconnect the receiver from the mains or switch off the
power! Doing so might damage your receiver and will void warranty!
WARNING: Old channel list and favourites will be overwritten.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline or send email to our Support via www.strong.tv. Do NOT try to
open or disassemble the receiver. It may cause a dangerous situation and warranty will be void.
Problem Possible cause What to do
LED indicator and
LED display are not
switching on.
The mains lead is unplugged.
Power switch at rear panel is
set to OFF.
Check the mains plug. Switch main
power to ON.
No signal found The antenna is disconnected
The antenna is damaged/
misaligned
Out of digital signal area
Active antenna requires
to switch ON the antenna
power/external power
Check the lead of the antenna
Check the antenna
Check with your dealer
Switch the antenna power of the
receiver ON/connect external power
No picture or sound on
TV or amplifier
HDMI or SCART is not selected
on your TV or amplifier or the
unit is set to higher resolution
as the TV supports.
TV/amplifier is not switched
on
Switch to correct TV/amplifier input
Select lower resolution on receiver
Switch TV/amplifier on.
Check if S/PDIF connection is used.
Scrambled channel
message
Channel is scrambled Select an alternative channel
No response to the
remote control
The receiver is off
The remote control is not
aimed correctly
The front panel is obstructed
The batteries of the remote
control are exhausted
Plug in and turn on the plug
Aim the remote control at the front
panel
Avoid obstructions
Replace the batteries of the remote
control
21

Strong SRT 8213 Specifications

General

Aspect ratio	4:3, 16:9
Signal source	Ethernet (RJ-45), Terrestrial
Video resolutions	1280 x 720, 1920 x 1080 pixels
Supported video modes	576i, 576p, 720p, 1080i, 1080p
Digital signal format system	DVB-T2
Personal Video Recorder (PVR) included	Yes
Audio formats supported	AC3, PCM
Video formats supported	H.264, H.265, HEVC, MPEG2, MPEG4
Wi-Fi	No
USB 2.0 ports quantity	1
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	0
Tuner type	Digital
Demodulation	16-QAM, 64-QAM, 128-QAM, 256-QAM, QPSK
Product color	Black
Audio decoders	Dolby Digital Plus
Number of tuners	1 tuner(s)
Channels quantity	700 channels
Audio output channels	2.0 channels
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 85 %
AC input voltage	100 - 240 V
Power consumption	1000 mA
AC input frequency	50 - 60 Hz
Power consumption (standby)	1 W
Power consumption (typical)	12 W

Weight and Dimensions

Depth	55 mm
Width	175 mm
Height	42 mm
Weight	130 g