1.3 Equipment Set-up
We recommend you to consult a professional installer to set up your equipment. Otherwise, please
follow the instructions below:
n Refer to the user manual of your TV and, if applicable, your antenna.
n Make sure that the HDMI cable and, if applicable, outdoor components are in a good condition.
n If you use the TV SCART connection, use a well shielded SCART cable.
This manual provides complete instructions for installing and using this receiver. The following
symbols will serve as follow.
WARNING: Indicates warning information.
NOTE: Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver.
(Bold characters)
Move to Represents a menu item within a window.
(Italic characters)
1.4 Accessories
n Installation instructions
n 1 remote control unit
n 2x batteries (AAA type)
n 1x Power Adapter 12 V, 1 A (1,5m cable)
WARNING: The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators instead of batteries are going to be used (e.g. NiMH), we
recommend using types with low self-discharge to ensure long time
operation of your remote control.
1.5 Usage of external USB devices
n It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible
to USB 2.0 specifications, recording, playback and other multimedia functions of the receiver
might not work properly.
n STRONG cannot guarantee the playback of files although extensions are listed, as it depends on
codec, data bit rate and resolution used (all MPEG codec formats are supported).
n It is advised not to store important information on USB storage devices used with the receiver.
n Always make backups of data on your USB storage device before using it with this receiver.
n STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
4
To Next Page
Loading...
Need help?
General
Weight and Dimensions
