Forgotten PIN code
Forgotten channel
lock code
Default PIN is 1234
Contact your local Service Hotline
or send an email to our Support via
www.strong.tv
After moving the
receiver to another
room/area you are no
longer able to receive
digital reception
The antenna signals are too
weak
The signal strength/quality
might be less than before, if
using an indoor antenna
Press INFO on the remote control to
keep the signal bars on screen and
adjust the antenna for (maximum)
reception. Alternatively, do a rescan of
the channels.
When using an active antenna, check
if the antenna power setting is On
Try using an outdoor antenna
The receiver switches
off automatically
The Auto Standby function is
enabled
Disable Auto Standby. See section
7.3.3.1 for details.
Playback of video
causes picture freeze/
macro blocks or similar
distortion, especially on
HD content
The read speed of your USB
device could be too low
Make sure to use a USB storage device
with sufficient speed and space. Pen
drives (‘USB sticks’) may not support
sufficient speed.
9.0 TECHNICAL SPECIFICATIONS
Tuner
Input connector: IEC60169-2, female, 75 Ohm nominal
Input frequency range: VHF: 174 ~ 230 MHz
UHF: 474 ~ 790 MHz
Input signal level: DVB-T2: -70 dBm ~ -25 dBm
Antenna power: 5 V DC, max. 50 mA, short cut protected
Demodulator
Demodulator: QPSK, 16/64/128/256 QAM
DVB-T2 (EN 302 755)
Transmission mode: normal and extended
Guard intervals: DVB-T2 = 1/128, 1/32, 1/16, 19/256, 1/8, 19/128, ¼
Video Decoder
Video resolution: 576i, 576p, 720p, 1080i, 1080p
Decoding & Video Out: MPEG 2/4 H264/H265 (HEVC) - HD /PAL
Aspect Ratio: 4:3 and 16:9
Aspect Conversion: Pan & Scan, Letterbox and Combined
Audio Decoder
Audio support: Dolby Digital Plus*/AC3+/PCM
MPEG MusiCam Layer II
22
To Next Page
Loading...
