EasyManua.ls Logo

Stryker altrix - Removing and Replacing the Reservoir; Filling the Reservoir with Sterile Distilled Water

Stryker altrix
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RReemmoovviinngg aanndd rreeppllaacciinngg tthhee rreesseerrvvooiirr
The removable reservoir enables you to fill or drain the reservoir away from the controller without interrupting therapy. You
will need to have the reservoir installed before starting a therapy.
CCAAUUTTIIOONN -- Do not place your fingers in between the reservoir and the sides of the controller, to avoid the risk of pinching
your fingers.
To remove the reservoir, pull forward at an angle, and lift out the reservoir (Figure 16).
A
B
C
FFiigguurree 1166 RReemmoovvaabbllee rreesseerrvvooiirr
1. To replace the reservoir, align the base of the reservoir over the drain (C).
2. Align the notch on the back of the reservoir (A) with the hook on the controller (B) (Figure 16)
3. Push the reservoir back into place. Make sure that the reservoir is secure to avoid water leakage.
FFiilllliinngg tthhee rreesseerrvvooiirr wwiitthh sstteerriillee ddiissttiilllleedd wwaatteerr
The removable reservoir is translucent for you to see the water levels.
CCAAUUTTIIOONN
Always use sterile distilled water or distilled water that has been passed through a filter less than or equal to 0.22
microns with this product.
Always fill the reservoir with room temperature sterile distilled water to reduce the risk of burn.
Do not overfill the reservoir to avoid the risk of water spillage and fall.
To fill the removable reservoir with sterile distilled water:
1. See
Removing and replacing the reservoir
(page 25).
2. Fill the reservoir with five liters of sterile distilled water. Do not fill past the top fill line to avoid water overflow (Figure 17).
8001-109-001 Rev C.0 25 EN

Table of Contents

Other manuals for Stryker altrix

Related product manuals