Stryker altrix - Storing the Power Cord and Hoses

FFiigguurree 2222 –– CClliikk--TTiittee ooppeenn
4. Raise all the hoses completely above the connection ports on the controller.
5. Allow the product to drain for a minimum of two minutes.
6. Push down on the drain plug to close the drain.
7. Replace the reservoir.
SSttoorriinngg tthhee ppoowweerr ccoorrdd aanndd hhoosseess
After you complete therapy or when you transport the product, store the power cord and hoses.
CCAAUUTTIIOONN
• Do not hang items on the controller handle to avoid the risk of tipping the product.
• Always store the power cord, cables, and hoses before you transport the product to reduce the risk of trip hazard.
To store the power cord and hoses:
1. Connect the ends of the connector hoses together, if applicable.
2. Coil and fasten the hose with the management straps (Figure 23).
3. Unplug the power cord from the wall outlet and store with the management straps (Figure 23).
8001-109-001 Rev C.0 33 EN