Stryker altrix - EMC Information

EEMMCC IInnffoorrmmaattiioonn
GGuuiiddaannccee aanndd mmaannuuffaaccttuurreerr’’ss ddeeccllaarraattiioonn -- eelleeccttrroommaaggnneettiicc eemmiissssiioonnss
The AAllttrriixx system is intended for use in the electromagnetic environment specified below. The customer or the user of
AAllttrriixx should assure that it is used in such an environment.
EEmmiissssiioonnss tteesstt
CCoommpplliiaannccee EElleeccttrroommaaggnneettiicc eennvviirroonnmmeenntt
RF Emissions
CISPR 11
Group 1
The AAllttrriixx system uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF Emissions
CISPR 11
Class A
The AAllttrriixx system is suitable for use in all
establishments other than domestic and those
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
220-240V/50Hz
220V/60Hz
Does not apply to 100V
50/60Hz or 120V/60Hz
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
Complies
220-240V/50Hz only
NNoottee -- The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). If it is used in a residential environment, for which CISPR 11 class B is normally required, this equipment might not
offer adequate protection to radio frequency communication services. The user might need to take mitigation measures,
such as relocating or reorienting the equipment.
RReeccoommmmeennddeedd sseeppaarraattiioonnss ddiissttaanncceess bbeettwweeeenn ppoorrttaabbllee aanndd mmoobbiillee RRFF ccoommmmuunniiccaattiioonnss eeqquuiippmmeenntt aanndd tthhee
AAllttrriixx ssyysstteemm
The AAllttrriixx system is intended for use in an electromagnetic environment in which radiated RF disturbances are
controlled. The customer or the user of AAllttrriixx can help prevent electromagnetic interferences by maintaining a minimum
distance between portable and mobile RF communications equipment (transmitters) and the AAllttrriixx system as
recommended below, according to the maximum output power of the communications equipment.
RRaatteedd mmaaxxiimmuumm oouuttppuutt
ppoowweerr ooff ttrraannssmmiitttteerr
W
SSeeppaarraattiioonn ddiissttaannccee aaccccoorrddiinngg ttoo ffrreeqquueennccyy ooff ttrraannssmmiitttteerr
m
115500 kkHHzz ttoo 8800 MMHHzz
DD==((11..22)) ((√√
PP ))
8800 MMHHzz ttoo 880000 MMHHzz
DD==((00..3355)) ((√√ PP ))
880000 MMHHzz ttoo 22..77 GGHHzz
DD==((00..7700)) ((√√ PP ))
0.01 0.12 0.035 0.07
0.1 0.38 0.11 0.22
1 1.2 0.35 0.7
8001-109-001 Rev C.0 57 EN