Stryker FL28C - Scale System Control Panel Guide (Optional)

20 72-0908E OM FL28C REV B www.stryker.com
Return To Table of Contents
SCALE SYSTEM CONTROL PANEL GUIDE (OPTIONAL)
WARNING
The weight system (optional) is intended to assist in the monitoring of the patient’s weight variation. Under no circumstances
should its readings be used as sole reference for medical treatment.
Note
When the bed is powered on, the scale display will show a welcome message and the version (X.X) of the control
software:
S T R Y K E R
S C A L E V X . X
I: / Enter Control
• Press once to activate the display. The Scale mode will be displayed.
• The display may be shut off by pressing the key.
• Press ENTER when instructed to do so.
J: Zero Control
• To zero the scale
H: Menu Up/Down Controls
• Press either control repeatedly until desired mode is reached.
G: Scale Display
Scale Menu Modes
Order of appearance of the modes when the MENU Down control is pressed repeatedly:
Mode First Line Appearing
Scale Weight Angle
Gain or Loss Gain Or Loss
Gain or Loss Reference Weight Gain/loss Zero
Change Equipment Change Equipment
Change Patient Weight Change Patient Weight
Select Weight Unit (lb/kg) Units
Note
• The scale readings must be within the range specified in the Specifications section of this manual. Otherwise, the
scale must be calibrated. Refer to the scale calibration procedure of the Maintenance Manual.
• The scale does not operate when the bed is inclined more than 12° in the Trendelenburg or reverse Trendelenburg
position. The LCD will display a warning message and the current bed angle, but not the patient’s weight.
• Should the message “No Scale Found” appear on the screen during the normal course of operation of the scale,
press the enter key. Data will reappear on the screen and the current operation will resume. If the message remains,
contact Technical Support.
I
JH
G
Figure 2.14B
Operation Guide