www.stryker.com 72-0908E OM FL28C REV C 43
Return To Table of Contents
Fixed Two Stage I.V. Pole - FA64174
The fixed two stage I.V. pole FA64174 is a permanently attached, telescoping I.V. pole. The extension of the telescoping
section provides a second height position.
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation. Refer to
the “Add / Remove Equipment” procedure (page 22).
INSTALLATION
Tools Required:
• 1/2” Combination Wrench
Procedure:
1. Using a 1/2” combination wrench, remove the bolt (A) and spring washer (B) from the base of the I.V. pole.
2. Install the I.V. pole into the socket and attach it using the bolt and spring washer.
Note: The bolt is coated with “Scotch Grip”. The coating becomes less effective once the bolt is tightened and removed
thereafter. Replace the bolt if the I.V. pole is removed and reinstalled in another socket or bed.
OPERATION
1. To increase the height of the pole, pull up on the
telescoping portion (C) until it locks into place.
2. Rotate the I.V. pole hangers (D) to the desired
position and hang the I.V. bag(s).
WARNING
The weight of the I.V. bags must not exceed 40 lb
(18 kg).
D
C
B
A
To Next Page
Loading...
