www.stryker.com 72-0908E OM FL28C REV C 37
Return To Table of Contents
Bed Extender without Scale - FA64164
The bed extender is designed to temporarily increase the mattress support by 10” on beds not equipped with the optional
scale system. It also allows the installation of an 80” or 84” long mattress. A cushion (DM64063 for a 6” thick mattress)
must be ordered separately to accompany the extension.
WARNING
• The bed exit system must be adjusted if this accessory is added when either system is in operation. Refer to the
“Add / Remove Equipment” procedure (page 22).
• The surface added by the bed extender is not included in the area monitored by the Bed Exit system.
• Do not perform this procedure while a patient is in the bed.
INSTALLATION
Tools Required:
• #2 Phillips Screwdriver
Procedure:
1. Apply the brakes.
2. Unplug the bed from the wall socket.
3. Remove the foot board.
Configuration with 80” Mattress Configuration with 84” Mattress
Note the position of the foot
end mattress retainer.
Support assembled
To Next Page
Loading...
