Stryker FL28C - Bed Extender with Scale - FA64173

www.stryker.com 72-0908E OM FL28C REV C 39
Return To Table of Contents
Bed Extender with Scale - FA64173
The bed extender is designed to temporarily increase the mattress support by 10” on beds equipped with the optional
scale system. It also allows the installation of an 80” or 84” long mattress. A cushion (DM64063 for a 6” thick mattress)
must be ordered separately to accompany the extension.
WARNING
• The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation.
Refer to the “Add / Remove Equipment” procedure (page 22).
• The surface added by the bed extender is not included in the area monitored by the Bed Exit system.
• Do not perform this procedure while a patient is in the bed.
INSTALLATION
Tools Required:
• #2 Phillips Screwdriver
Procedure:
1. Apply the brakes.
2. Unplug the bed from the wall socket.
3. Remove the foot board.
4. Before installing the extender, adjustments must be made depending on the length of mattress being used:
Configuration with 80” Mattress Configuration with 84” Mattress
Note the position of the foot
end mattress retainer.
Support assembled