Stryker FL28C - Page 40

40 72-0908E OM FL28C REV B www.stryker.com
Return To Table of Contents
Bed Extender with Scale - FA64173
INSTALLATION (CONTINUED)
• For an 80” mattress, assemble the support on the bed extender using the screws provided with a #2 Phillips
screwdriver. Do not move the foot end mattress retainer, it is positioned for an 80” mattress from the factory.
See the “Configuration with 80” Mattress” illustration on page 39.
• For an 84” mattress, move the foot end mattress retainer to the position nearest to the bed extender foot end
by pressing inward on its lateral pins. Do not assemble the support to the extender. See the “Configuration with
84” Mattress” illustration on page 39.
5. Insert the mattress support extension posts into the foot board mounting sockets.
6. Install the cushion onto the bed extender. Do not use the cushion straps; squeeze the cushion between the mattress
end and the mattress retainers on the bed extender. See the illustration below.
7. Insert the foot board into the mounting sockets on the bed extender.
8. Verify proper operation of the unit before returning it to service.
WARNING
The bed extender must be removed before using the emergency crank (optional).
Bed Extender Cushion Installed