48 72-0908E OM FL28C REV B www.stryker.com
Return To Table of Contents
Traction Adapters
These adapters allow for the installation of traction frames. This applies to FA64188, FA64189, FA64190 and FA64191.
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation. Refer to
the “Add / Remove Equipment” procedure (page 22).
INSTALLATION
Tools Required:
• 1/2” Combination Wrench
Procedure:
1. Install the four adapters (A) into the corresponding holes located in the corners of the bed.
2. Using a 1/2” combination wrench, secure the washers (B) and bolts (C) provided.
Note: The bolt is coated with “Scotch Grip”. The coating becomes less effective once the bolt is tightened and removed
thereafter. Replace the bolt if the traction adapter is removed and reinstalled on another bed.
A
C
B
To Next Page
Loading...
