Stryker FL28C - Oxygen Bottle Holder - FA64169

36 72-0908E OM FL28C REV B www.stryker.com
Return To Table of Contents
Oxygen Bottle Holder - FA64169
The oxygen bottle holder accepts a 4” diameter oxygen bottle. It can be installed at the foot or head end of the bed.
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation. Refer to
the “Add / Remove Equipment” procedure (page 22).
INSTALLATION
Tools Required:
• None
Procedure:
1. Remove the lock pin (A) from the holder support rod.
2. Insert the support rod into the hole on the I.V. pole holder (B) a the head or foot end of the bed.
3. Bring the chain under the head or foot end casing and insert the lock pin in the hole (C) on the holder rod.
Note: The bottle holder installation must be finalized by installing the lock pin. The function of the pin is to prevent the
bottle holder from coming out of its position when an oxygen bottle is removed from it.
OPERATION
1. Insert the oxygen bottle into the holder.
WARNING
• The maximum load capacity of the oxygen bottle
holder is 75 lb (34 kg).
• Possible fire hazard exists when this unit is used
with oxygen administering equipment other than
nasal, mask type, or half be length tent type. It
is recommended to unplug the unit from the wall
socket when oxygen administering equipment is
used. When using a half bed length tent type,
ensure the siderails are outside the oxygen tent
and the oxygen tent should not extend below the
mattress support level.
A
B
C