32 72-0908E OM FL28C REV B www.stryker.com
Return To Table of Contents
Monitor Tray - FA64163
The monitor tray is designed to hold and secure a monitor using a Velcro strap. The tray can also be used as a writing
support. It folds down into a storing position.
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation. Refer to
the “Add / Remove Equipment” procedure (page 22).
INSTALLATION
Tools Required:
• None
Procedure:
1. Insert the monitor tray posts into the I.V. pole holders located on the foot end of the unit.
OPERATION
CAUTION
• Do not use the monitor tray as a push/pull device.
• Do not use an I.V. pole at the foot end of a unit equipped with this device.
1. To use the tray for monitor support, pull the lock pin (A), lift the tray and fold it back toward the head end of the
bed, and release the pin.
2. To use the tray for writing support, pull the lock (A) and lift the tray to about 30 degrees and release the pin.
3. To place the tray into its stored position, pull the lock pin (A), lower the tray to its lowest position and release the pin.
Note: Secure the monitor to the tray using the Velcro strap.
WARNING
The maximum load capacity of the tray is 40 lb (18 kg).
Lock pin
To Next Page
Loading...
