46 72-0908E OM FL28C REV B www.stryker.com
Return To Table of Contents
Fixed Three Stage I.V. Pole, Foldable - FA64170
The fixed three stage I.V. pole FA64170 is a permanently attached, telescoping I.V. pole. The extension of the telescoping
section provides several additional height positions. The I.V. pole can fold into a storage position.
WARNING
The scale and bed exit systems must be adjusted if this accessory is added when either system is in operation. Refer to
the “Add / Remove Equipment” procedure (page 22).
Tools Required:
• Ratchet with a 7/16” and 1/2” Socket
• 7/16” and 1/2” Combination Wrench
• #2 Phillips Screwdriver
I.V. POLE INSTALLATION
Note: The I.V. pole can only be installed on the right side of the
head end of the bed.
1. Remove the head board.
2. Using a 1/2” combination wrench, remove the bolt (A) and
spring washer (B) from the base of the I.V. pole.
3. Install the I.V. pole into the socket and attach it using the bolt
and spring washer removed in step 2.
Note: The bolt is coated with “Scotch Grip”. The coating becomes
less effective once the bolt is tightened and removed thereafter.
Replace the bolt if the I.V. pole is removed and reinstalled in an-
other socket or bed.
4. Using a 1/2” combination wrench, remove the two nuts (C)
and bolts (D).
5. Install the storage plate (G) and secure with the bolts and nuts
removed in step 4.
6. Reinstall the head board.
I.V. POLE OPERATION
1. Lift and pivot the pole from the storage position and push down until it is locked into the receptacle.
2. To increase the height of the pole, pull up on the first telescoping portion (E) until it locks into place.
3. To increase the height further, pull up on the second telescoping portion (F). Release the section at any desired
height and it will lock into place.
4. To lower the second telescoping section, push up on the red part of the handle (J) while holding the section. Lower
the section to the desired height and release the handle to lock the section into place.
5. Rotate the I.V. pole hangers (H) to the desired position and hang the I.V. bag(s).
WARNING
The weight of the I.V. bags must not exceed 40 lb (18 kg).
6. To store the I.V. pole, push up on the red portion of the handle (J) while holding onto the second section and lower
it. Turn the latch (K) clockwise to lower the first section. Lift the pole to remove it from the receptacle. Fold the pole
down and store it on the bracket.
H
E
K
A
B
G
D
F
C
J
To Next Page
Loading...
