www.stryker.com 72-0908E OM FL28C REV C 45
Return To Table of Contents
Fixed Two Stage I.V. Pole, Foldable - FA64171
WARNING
Ensure all the connectors stay plugged into the electronic board if it is present on the head casing cover.
BUMPERS INSTALLATION
1. Unplug the power cord from the bed.
2. Using a 1/2” combination wrench with a 1/2’’ socket, remove the bolts, washers and nuts holding the rollers in place.
3. Using a Phillips screwdriver, remove the screws (L) holding the head casing cover.
4. Using a 7/16” combination wrench with a 7/16” socket, remove the nuts (J) and the bolts (H) holding the bumper
brackets to the head casing cover.
5. Mount the new brackets (F) on the head casing cover using the new hexagonal bolts (H) and nuts (J), as shown
in the drawing below.
6. Install the head casing cover back on the bed frame using the screws (L) removed in step 3.
7. Insert the rollers (G) on each bracket and secure using the new hexagonal bolts (I) and nuts (K).
Note: When tightening the nuts, make sure that there is enough room for the rollers to spin freely.
J
I
K
G
H
F
To Next Page
Loading...
