22 72-0908E OM FL28C REV B www.stryker.com
Return To Table of Contents
SCALE SYSTEM (CONTINUED)
Adding or Removing Equipment when a Patient is on the Bed
• Press to activate the scale display. Access the Change Equipment mode using the Menu Down key, the display
will read:
Change Equip
Press Enter
• Press Enter. The display will read:
Release to Start (release Enter), followed by:
Do Not Touch Bed (ensure no one touches the bed while this message is displayed).
• The following message will then appear:
Add/Remove Equip
Press Enter
Signalling that equipment can now be added or removed from the bed. When done with the equipment, press Enter.
• Display will then read Release to Fin. (release Enter), followed by:
Do Not Touch Bed (ensure that the patient remains still and that no one touches the bed while this message is
displayed).
The system will return to the Scale mode displaying the patient’s weight (the weight should be the same as the one
displayed before the procedure).
Manually Changing the Numerical Value of Displayed Weight
In certain circumstances, it may be necessary to manually change the patient’s weight displayed. To do so:
• Press to activate the scale display. Access the Change Patient Weight mode using the Menu Down key. The
display will read:
Change Patient Weight
Press Enter
• Press Enter. The display will read:
Release to Change Weight (release Enter), followed by:
Do Not Touch Bed (ensure no one touches the bed while this message is displayed).
• The display will then read XXX.X lb / press Enter. Adjust the weight using the Menu Up/Down controls.
When the desired weight is entered, press Enter. The system will return to the Scale mode and display the modified
weight.
Note
The Change Patient Weight mode should not be used systematically for new patients. The scale should be zeroed each
time a new patient occupies the bed.
Changing the Weight Unit of Measure
• Press
to activate the scale display. Access the Select Weight Unit (lb/kg) mode using the Menu Up key. The
display will read:
Units
Press Enter
• Press Enter. The display will read:
lb and OR kg and
Press Enter Press Enter
• Select the weight unit using the Menu Up or Down control and press ENTER. The system will return to the Scale
mode with the weight displayed in the unit chosen.
Operation Guide
To Next Page
Loading...
