Stryker FL28C - Page 63

www.stryker.com 72-0908E OM FL28C REV C 63
Return To Table of Contents
Guidance and Manufacturer’s declaration - Electromagnetic Emissions
The GoBed
®
II MedSurg Bed, Model FL28C is intended for use in an electromagnetic environment specified
below. The customer or the user of the GoBed
®
II MedSurg Bed, Model FL28C should assure that it is used
in such an environment.
Emissions Test Compliance Electromagnetic Environment
RF Emissions
CISPR 11
Group 1
The GoBed
®
II MedSurg Bed, Model FL28C uses RF
energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
RF Emissions
CISPR 11
Class A
The GoBed
®
II MedSurg Bed, Model FL28C is suitable
for use in all establishments other than domestic and
those directly connected to the public low voltage power
supply network that supplies buildings used for domestic
purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
Complies
GOBED
®
II MEDSURG BED, MODEL FL28C (CONTINUED)
EMC Information