Stryker L10 - Administration

27
Administration
1. Ensure there is a port available for the injection of the ICG solution
followed by the saline ush.
2. Draw the required dosage of ICG solution for each planned imaging
sequence into separate syringes.
3. Draw approximately 10 –12mL of normal saline for each planned imaging
sequence into separate syringes.
Note: There should be the same number of saline syringes (or more) than
the prepared ICG solution syringes. If the saline syringes are prepared
prior to the procedure, place them in a convenient and sterile location for
use at the time of imaging.
4. Administer 2.5mg of the prepared ICG solution intravenously.
• For visual assessment of the major extrahepatic bile ducts, administer
ICG at least 30 minutes prior to near-infrared imaging.
• For visual assessment of vessels, blood ow and related tissue
perfusion, administer ICG immediately before near-infrared imaging.
5. Immediately follow each ICG injection with a tight bolus injection of
approximately 10 –12mL of normal saline.
After each injection of ICG solution, the ENV mode should be able to visualize
a uorescence response in blood vessels and tissue within severalseconds.
Note: Once the ICG solution is prepared, it must be used within 6 hours. If
additional ICG solution is required to administer, reconstitute a second vial of
ICG after the rst reconstituted solution has been used completely.
ICG Overview
• Injection method: Intravascular
• Recommended dosage: Typically 2.5mg
ICG Storage
• Discard any unused reconstituted ICG after the surgery is complete.
• Store AIM IC-GREEN at ambient room temperatures of 20 – 25°C
(68 – 77°F).
• Do not use AIM IC-GREEN if the expiration date on the packaging has
passed.