3
Warnings: Laser
IMPORTANT SAFETY NOTICE - LASER RADIATION:
The L10 LED Light Source with Advanced Imaging Modality
Technology (or “L10 AIM Light Source”) is a laser product that
uses a Class 1 laser (IRIS mode) and a Class 1M laser (ENV mode).
Use of controls or performance of procedures other than those
specied herein can result in hazardous laser radiation exposure
and can cause severe eye injury to the patient or user.
To prevent exposure to laser radiation, follow all warnings and
guidelines presented below and throughout this user manual.
1. Observe the warning label shown below (located on the rear panel).
2. Protect the L10 AIM Light Source against unqualied use.
3. Wear eye protection as appropriate. Refer to any applicable regional
regulations or standards for personal protective equipment.
4. Do not manipulate tissue while ENV mode is activated. The 1588AIM
Video Camera is intended to visualize tissue manipulation only while ENV
mode is o.
5. Do not view the laser output in ENV mode with telescopic optical
instruments (for example, microscopes or magniers). Do not direct the
laser output in ENV mode into an area where such instruments are likely
to be used.
6. Do not activate ENV mode when the endoscope is outside of the patient’s
body.
7. When ENV mode is activated, never look into the following apertures or
direct the light emitted from the apertures toward another person:
• the light cable connection on the light source (if the cable is not
attached)
• the end of the light cable (if the SafeLight adapter is attached)
• the endoscope tip
8. When ENV mode is activated, never leave a SafeLight adapter attached
to the light cable without an endoscope attached. Laser radiation can
continue to emit from the adapter.
9. Power o the light source (or place it in Standby mode and disable ENV
mode and IRIS mode) before connecting or removing the light cable,
endoscope, or disposable bers.
To Next Page
Loading...
Need help?
General
