• Do not exceed 1500 psi (130.5 bar) as the maximum water pressure. If you use a hand held wand to wash the product,
keep the pressure nozzle at a minimum of 24 in. (61 cm) from the product.
• Always use authorized parts to avoid the risk of product damage.
• Always check hoses and lines regularly to avoid damage to the cot. Check and tighten loose connections. Hydraulic
lines, hoses, and connections can fail or loosen due to physical damage, kinks, age, and environment exposure.
• Do not tip the cot onto its load wheels and actuate the product as this will allow air to enter the hydraulic system.
• Do not lubricate the bearings in the X-frame as it will degrade the performance of the cot and may void its warranty.
PPiinncchh ppooiinnttss
WWAARRNNIINNGG -- Always keep your hands clear of the red safety bar pivots when you load, unload, or change the height
position of the cot.
FFiigguurree 11 –– PPiinncchh ppooiinnttss
EN 6 6516-209-001 Rev D.0
To Next Page
Loading...
