IItteemm IInnssppeecctt
Hydraulic velocity fuse - place a weight of approximately 50
lb (23 kg) on the cot, raise the cot, lift the cot with two
operators, pull the manual backup release handle, rapidly
set the cot down, and make sure that the cot does not drop
Electronic controls Extend cot to raised position, measure and check load
height
Jog function operates
High speed retract works
Switches No damage or wear to either switch
Both switches operate
Litter No bent, broken, or damaged components
No damage or tears on cot grips
Base No bent, broken, or damaged components
Cot retaining post is secure. If not, replace the screw
No excessive damage to X-frame guards
Wheels Free of debris
Head section No bent, broken, or damaged components
Grip bar has no excessive damage or tears
Load wheels are secure and roll
EEvveerryy 1122 mmoonntthhss oorr 2244 hhoouurrss
Inspect these items every 12 months or 24 hours, whichever comes first.
IItteemm IInnssppeecctt
Settings Cot and fastener fit and function
Safety bar connects to the vehicle safety hook
Cylinder Cylinder is adjusted - lock nut is tight and the cot stops
moving when it hits the dead stops
Manual backup release handle Returns to the stowed position
Litter All welds are intact, not cracked, or broken
Warning labels present, legible
Base All welds are intact, not cracked, or broken
Wheels Check and adjust wheel locks
6516-209-001 Rev D.0 53 EN
To Next Page
Loading...
Need help?
General
